My name is Connor McGoey. I am an industrial designer and I work at NextFab as a technical supervisor. Here is one of my personal projects I’ve recently completed at NextFab.
The legs were salvaged from a discarded kitchen/dining room table. I used a chop saw to cut the legs to a desired length. I then marked and cut out notches for mounting the legs to the side of the table using a combination square for measurement. The marked cuts were cut using the band saw with use of the fence to achieve a strait cut. The legs were attached using wood glue and brad nails.
The body of the table is constructed of chipboard commonly used in exterior building construction prior to insulation and siding. The 1/2” piece of chipboard was cut to lengths using the Sawstop table saw. Construction of the body table was assembled using wood glue and 1” brad nails. Lastly the table top/window frame was sanded using and palm sander with an 80 grit sanding pad to remove decades of old paint. The top was mounted using hinges at the rear as well tension hinges mounted on the left and right hand exterior sides to prevent the lid from slamming shut. The piece will be finished with a nature nut oil to provide the lowest possible impact to the environment in it’s continuation toward it’s next life cycle.
What are you working on?